Fiskars telescoping pruning stik manual transfer

If you want to use a plastic rope, cauterize its ends with heat from a flame to keep it from unraveling. Tips Cotton laundry line does just fine for restringing a limb pruning pole, or you can use a combination cotton-polyester designed for outdoor use. Keep your fingers out of the striking hook as you handle the pole head. Things Needed Utility knife Screw driver or awl Replacement rope Warnings The cutting blade on a tree pruner is sharp. Thread that end through the hole on the plastic pulling handle. Trim the rope with a utility knife, if needed, to just short of the extended or full length of the pole.

Fiskars Telescoping Pruning Stik Ly Full Length Of Thread the other end of the rope through the eye-bolts or other guides on the poles that keep the rope secure as you work on trees. Pull the two loops tight by pulling the loose end and squeezing the two loops together. Then make a second loop around with the loose end, this time pulling the loose end between the first and second loops toward you - or in the opposite direction of the first. Secure the rope to the clip using two half-hitches or any other knot that will hold together firmly.įor a double half hitch, bring the loose end around the rope going into the clip from the bottom pulley, then through the loop. This time, thread the rope around the pulley from the pole side toward the outside.Ĭontinue upward with the end of the rope and run it through the clip on the end of the top pulley, again from outside through the clip, and in toward the cutting blade assembly. Pull the rope through and into the slide around the bottom pulley. Thread one end of the rope through the top pulley from the outside in toward the cutting blade assembly.

Use a screwdriver or awl to push the rope through pulleys and untie knots. Fiskars Telescoping Pruning Stik Ly Full Length Ofįiskars Telescoping Pruning Stik Ly Driver Or Awl.Fiskars Telescoping Pruning Stik Ly Driver Or Awl.

Fiskars telescoping pruning stik manual transfer